Starburst Bracelet: Project Instructions

Starburst Bracelet: Project Instructions

Posted by Eureka! Beads on 18th Mar 2019

This quick and easy project uses wire mesh tubing and glass crystals to create a fantastic effect! Follow our simple instructions to make your own.

MATERIALS REQUIRED

  • 1 x 6mm Clip In Magnetic Tube Clasp Set
  • 20cm x 6mm Wire Mesh Tubing
  • 150 x Crystal Clear 3mm Bicone Glass Beads

TOOLS REQUIRED

  • Wire Cutters
  • E6000 Glue

INSTRUCTIONS

Take hold of the twist clasp and taking note of how it clips together, unclip the clasp and carefully line the outside hollow with glue. Take hold of the mesh tubing and gently squish the end together and then apply glue to the end. Allow 3 minutes to slightly dry then place the two glued pieces together. Allow a minimum of 2 hours to set before starting on the next step.

Fill the mesh with the bicone crystals being careful to not overfill causing bulges. Once you are near the end, measure the bracelet against your wrist and cut the mesh tubing to the correct size with your wire cutters. Apply glue to both the end of the mesh tubing and the outside hollow of the other end of the clasp. Wait 3 minutes and then place the two glued pieces together.

Wait 24 hours and then your bracelet is ready to wear.

© www.eurekabeads.com.au These free beading instructions may be used for personal use only [EX99341]