Red Diamante Rondelle Bracelet: Project Instructions

Red Diamante Rondelle Bracelet: Project Instructions

Posted by Eureka! Beads on 20th Mar 2019

Our rondelle crystal beads fit snugly into the 8mm rondelle diamante spacers, making this bracelet truly stand out. As simple as can be, follow our instructions to find out more.

MATERIALS REQUIRED

  • 30cm tigertail
  • 2 small crimps
  • 2 strong jump rings
  • 2 crimp covers
  • 22 x 8mm rondelle glass crystal beads
  • 21 x 8mm rondelle diamante spacers
  • 1 fancy round diamante magnetic clasp

TOOLS REQUIRED

  • 2 pairs of Crimping Pliers
  • Wire Cutters

INSTRUCTIONS

Pick up your piece of tigertail and thread it through a small crimp, then through a strong jump ring. Thread back through the small crimp and pull up tight. Squish securely and cut off any excess tigertail. Place a crimp cover around the squashed crimp and gently squish into a round ball with your pliers to hide the crimp.

Next, thread on:

  • an 8mm rondelle glass crystal bead
  • an 8mm rondelle diamante spacer

Repeat pattern another 21 times, so that you have 22 glass crystals on your bracelet. Finish by threading on one more 8mm rondelle diamante spacer, followed by small crimp. Thread through a strong jump ring, then back through the small crimp. Pull up tightly (but leave enough space to put another crimp cover over the crimp) and squish down the small crimp. Cut off any excess tigertail. Place a crimp cover around the squashed crimp and gently squish into a round ball with your pliers to hide the crimp.

Open up one of the strong jump rings and thread on one end of the magnetic clasp. Close securely. Open up the other jump ring and thread on the other end of the magnetic clasp. Close securely. Your bracelet is now ready to wear!

© www.eurekabeads.com.au These free beading instructions may be used for personal use only [EX50211]