Rose Purple/Copper 2 Strand Bracelet: Project Instructions

Copper findings coupled with rose coloured crystals give this two strand bracelet a beautiful look. Use our free instructions to learn how to make this tigertail bracelet!

MATERIALS REQUIRED

18 x 8mm round faceted glass crystals
8 x 3 strand fancy filigree spacers
1 magnetic clasp with loops
2 filigree metal tubes
2 jump rings
2 small tube crimps
40cm tigertail

TOOLS REQUIRED

Wire Cutters
Crimping Pliers
Twirly Wirlies

INSTRUCTIONS

Pick up the tigertail and thread through one of the jump rings. Continue threading until the jump ring sits halfway along the strand. Fold the strand of tigertail in half, and thread a small tube crimp over the two strands and up to the jump ring. Crimp down securely.

Thread a filigree metal tube over the two strands, so that it sits up tight next to the jump ring, hiding the crimp. Now, separate the two strands, and thread an 8mm round faceted glass crystal onto each strand. Then thread each strand through either side of the 3 strand fancy filigree spacer bar.

Repeat this pattern until you have 8 3-strand fancy filigree spacers threaded on. Finish with one more round faceted glass crystal on each strand.

Bring the two strands together again, and thread on a filigree metal tube, followed by a small tube crimp. Thread on the other jump ring, then take the tigertail back through the crimp. Pull up tightly, squish down the crimp and cut off any excess tigertail.

Open up one of the jump rings and thread on one end of the magnetic clasp, then close securely. Open up the other jump ring, thread on the other end of the magnetic clasp and close securely. Your bracelet is now ready to wear!

20th Mar 2019 Eureka! Beads